Connect a light
Read the status of a flashlight with the LuxLibre firmware, change its settings and choose the colours of its colour beam. For the ESP32-C3 lights with a USB-C port: EDCO, EDCO Mini and EDCO Prism.
Uses Web Serial: Chrome or Edge on a computer, with a USB-C data cable. Phones and tablets cannot do this.
This browser cannot connect to a light. It has no Web Serial. Use Chrome or Edge on a computer (Windows, macOS, Linux or ChromeOS). The demo works here.
The light does not show up
- Use a USB-C cable that carries data. Some cables only charge.
- Tick Show all serial ports and look for a USB JTAG/serial port.
- Close other programs and tabs that use the port, such as a serial monitor or the firmware installer.
- On Linux your user may need to be in the
dialoutgroup. - The light needs the LuxLibre firmware 0.4 or newer.
The light keeps working while it is connected, and its button always has priority. Changes take effect at once; Save to the light keeps them after a restart. Everything runs in your browser: nothing is uploaded.
Status
Updated every 2 s-
- Light
- -
- Beam
- -
- Level
- -
- Battery
- -
- Cell voltage
- -
- Temperature
- -
- Cell current
- -
- Limits
- -
White beam
1 is the dimmest, 150 the brightest. The heat and battery limits still apply.
Colour beam
The LEDs' own colours decide what you see, so the beam only comes close to the colour on the screen.
Switches the colour beam on in the chosen colour.
On the light
- 5 clicks from off
- colour beam on
- 2 clicks
- next colour
- 4 clicks while on
- switch between the white and the colour beam
- Hold
- brighter or dimmer
All settings
A change is sent when you leave the field or press Enter. The light uses it at once and keeps it after a restart only once you save.
Put all settings back to their defaults? The calibration (BAT_CAL, THM_OFFSET) is kept. The light uses the defaults at once; save to keep them.